StorageStor Index

COMMSCOPE adjustable slider bracket for 2-3/8"OD pipe. Adjustable for up to 7 degrees of taper. Order saddle mount and pipe seperately. Kit of two.
COMMSCOPE Adjustable Splice for use with roof mount coax kit. Joins two pieces of channel together. Creates up to 45 degree bend.For 4-run bridge kit.
COMMSCOPE Adjustable Tapered Pipe Mount 2-3/8 in OD x 48 in
COMMSCOPE Adjustable Tilt Pipe Mounting Kit for 2.0-4.5 in (60-115 mm) OD round members for panel antennas. Includes 2 clamp sets.
COMMSCOPE Adjustable Tilt Pipe Mounting Kit for 2.0"-4.5" (50-115mm) OD round members for panel antennas. Includes 2 clamp sets.
COMMSCOPE Adjustable Tilt Pipe Mounting Kit for 2.0"-4.5" OD round members for panel antennas. Includes 2 clamp sets.
COMMSCOPE Adjustable V-Stabilizer™ for a Tower large leg size (8–16 in)
COMMSCOPE Air Tank use with any dehydrator to increase system volume by 1.5 ft (42 liters).
COMMSCOPE AL4RPV-50 HELIAX® Plenum Rated Air Dielectric Coaxial Cable corrugated aluminum 1/2 in Red PVDF jacket 1000 ft
COMMSCOPE Alarm Retrofit Board Kit
COMMSCOPE Aluminum Bulk Pipe 2-3/8" OD x 240".
COMMSCOPE Aluminum fiber cable splitting tool.
COMMSCOPE Aluminum Plain End Pipe. 2 3/8" OD x 96" long.
COMMSCOPE AMPINNERGY® Power Entry Cable Assembly 8-wire/4-circuit (4-2-2) shared neutral 4 feet.
COMMSCOPE angle adapter with 3/8" tapped holes adapts hangers. Includes adapters set bolt and hanger hardware kit.
COMMSCOPE Angle for Microwave Strut Support Bracket 96 in 3/8 x 4 x 4 in Tie Back Support Angle
COMMSCOPE Antenna and RRU Cable Support Bracket for up to 12 Cables
COMMSCOPE Antenna and RRU Cable Support Bracket. Mounts up to 4 cable supports at 3” spacing. Adjustable stand-off distance. Mounts to 1.9”-3.5” pipes.
COMMSCOPE Antenna mounting bracket for mounting SBNHH-1D65C antenna to a 6 inch pole.
COMMSCOPE ARQ CA:CNT195 Braided Cable Assembly SMA-M to QMA-M 2M
COMMSCOPE Arrestor Trapeze Kit for 7-16 DIN type N or bolt-grounded surge arrestors 4-tier 6-hole pattern.
COMMSCOPE ASIG Smart Bias Tees for the bottom unit. 10-30 VDC. DIN Female (Ant) connector DIN male connector (BTS) AISG Input Connector (8-pin male).
COMMSCOPE Attenuator with SMA Male to SMA Female connectors 15 dB. DC to 18 GHz. 2 Watts.
COMMSCOPE Attenuator with SMA Male to SMA Female connectors 4 dB. DC to 18 GHz. 2 Watts.
COMMSCOPE Attenuator with SMA Male to SMA Female connectors 6 dB. DC to 18 GHz. 2 Watts.
COMMSCOPE ATTKITA-180-3 EWP180 ATT WAVEGUIDE KIT
COMMSCOPE AUT blank panel. Used to fill the slot if an auxiliary transport card is not used in a WSC subrack.
COMMSCOPE Automated Cable Preparation Tool for 1/2 in coaxial cable
COMMSCOPE Automated Cable Preparation Tool for 1/2 in coaxial cable FSJ4-50B coaxial cable with DClass Connectors
COMMSCOPE automated tool for 1/2" annular corrugated LDF4-50/A cable & connectors only. (Replacement blade kit number CPT-BKS1 #488113).
COMMSCOPE AWS IMF for Broadcast Auxiliary Service(BAS) co-location 4.3-10 connectors
COMMSCOPE AWS Twin In-Band Diplexer AWS ABCDEF1/HIJ Bands with AISG/DC Sense
COMMSCOPE AWS Twin In-Band Diplexer Tuning version 4 AWS ABC/EF Bands with AISG/DC Sense
COMMSCOPE Azimuth adjustment kit for 6 ft antennas
Commscope Back-up battery
COMMSCOPE Backing Plate 2 x 2 x 1/8 Accepts 3/8" hardware
COMMSCOPE Backing Plate 2x2x1/8 Accepts hardware
COMMSCOPE Backing Plate. 6 in x 6 in x 1/4 in. Requires 5/8 in hardware. Constructed of galvanized steel.
COMMSCOPE Backplate for Connectorizing EWP-132-137
COMMSCOPE Ballast Tray Extension Kit
COMMSCOPE Beacon Light Mount. Includes Beacon Light Bracket Weldment Half Clamp 1-1/2" to 5" OD 5/8" X 8" Galv Threaded Rod 5/8" Galv Flat Washer.
COMMSCOPE Bend Insensitive Singlemode Fiber DLC to DLC 12-Fiber Cable Assembly with pulling grip 125 m
COMMSCOPE Bend Insensitive Singlemode Fiber DLC to DLC 12-Fiber Cable Assembly with pulling grip 175 m
COMMSCOPE Bend Insensitive Singlemode Fiber DLC to DLC 36-Fiber Cable Assembly with pulling grip 250 m
COMMSCOPE Bend Insensitive Singlemode Fiber DLC to DLC 48-Fiber Cable Assembly with pulling grip 150 m
COMMSCOPE Black 3/4 in PVC tape 66 ft
COMMSCOPE BNC Male for CNT-195 Braided cable. 50Ohm 2.50kW Peak power. 0-6000 MHz.
COMMSCOPE BNC Male for CNT-400 braided cable.
COMMSCOPE Bolt on channel H-Frame
COMMSCOPE Boot assembly/feed thru kit.