QTY1 LEFT!!! BRAND NEW/FACTORY SEALED BOX WIC-1DSU-T1-V2 CISCO 1 PORT T1 FRACTIONAL DSU/CSU 1PORT T1/FRAC T1 DSU/CSU WAN Inte CARD: VER. 2 1.5 Mbps Part# WIC1DSUT1V2 Overview: The updated Cisco T1 data service unit/channel service unit (DSU/CSU) WAN Interface Card (WIC) is an integrated, fully managed DSU/CSU for T1 or fractional T1 service. The WIC-1DSU-T1-V2 is an updated version of the WIC-1DSU-T1, offering additional supported features with the same performance Manufacturer Website Address www.cisco.com Networking Module Type WAN Interface Card (WIC) Ports/Channels 1 x RJ-45 WAN Ports/Channels Details 1 x RJ-45 T1/FT1 WAN Media & Performance Data Transfer Rate 56Kbps to 64Kbps Fast Ethernet 1.544Mbps FT1 Protocols & Management Supported Protocols HDLC Management Full management features: Configuration - Capability for remote configuration via Telnet from Cisco IOS CLI. Monitoring - Router and DSU/CSU are manageable as a single SNMP entity; extensive DSU/CSU statistics are provided by the Cisco IOS CLI. Troubleshooting - Extensive loopbacks (including manual button for network line loopback), bit error rate tester (BERT) test patterns, alarm counters, and performance reports, all of which are accessible from Cisco IOS CLI. LEDs for carrier detect, loopback, and alarm functions. Convenient Telnet or Secure Shell (SSH) Protocol connection to the router eliminates the need for out-of-band management of external DSUs/CSUs Status LEDs LEDs: CD (data carrier detect) LP (loopback) AL (alarm) Miscellaneous Additional Information Benefits of an Integrated, Fully Managed Solution: Reduced Deployment, Management Time, and Costs: Flexibility and Investment Protection Single-Vendor Support Enhanced Reliability Consistency with WIC-1DSU-T1: Wet T1 Capable Short Cable Length Command Network Equipment Building Standards (NEBS) Line code: AMI B8ZS AMI ones density Forced/bit robbing (N X56) High-Level Data Link Control (HDLC) data inversion (N X64) Framing format: D4 (SF) ESF Output level (LBO) [dB0?]: 0 dB -7.5 dB -15 dB Input level: +1 dB0 to -24 dB0 Diagnostics: Loopbacks: Network line loopback; user initiated Recessed push button for network line loopback; toggle on/off Network line loopback; telco initiated Network payload loopback Local date terminal equipment (DTE) loopback Remote line and payload loopback (codes: V.54 loop up, and loop down) Self-test: Self-test activated by user Test patterns (BERT): 1:2, 1:5, 1:8, 3:24, QRW, All 0s, All 1s, user-programmable 24-bit patterns Network (T1) alarms: Loss of network signal (red alarm) Loss of network frame (blue alarm) (AIS) from network Receive (yellow alarm) from network [UNCLEAR] Performance reports and error counters: Cyclic redundancy check (CRC) Bipolar violation (BPV) OOF [EXPAND?] Errored seconds Burst errored seconds Severely errored seconds Ft and Fs framing errors for SF framing FPS [EXPAND?] framing errors for ESF framing 24-hour history stored in 15-minute increments SNMP Traps: Generated in response to alarms |